BAR-TEK® Intake Charge Pipe suitable for BMW B58B30 x40i BAR-TEK Motorsport 21bwm184 - сервиз

This aluminium charge pipe replaces the original plastic pipe. In vehicles with a performance upgrade, the boost pressure can cause the original pipe to break or burst. In the worst case, such a defect can lead to engine damage due to fragments being sucked in. At 70 mm, the aluminium charge pipe has a significantly larger diameter than the original. Air turbulence is reduced and the air flow is increased at the same time. This leads to better response behaviour of the turbocharger and a higher maximum possible output. The replacement does not require any intervention in the engine control unit. There is no risk of breakage even at exceptionally high charge pressures. In addition, our charge pipe has a thread (1/8\" inch, 21/64 fine thread) for retrofitting a water-methanol injection system. If this is not used, the screw should be secured urgently e. g. with Loctite.Installation is simple as this charge pipe is plug & play and is replaced with the OEM part. Features: Aluminium pressure pipe pressure and temperature resistant CNC-turned flanges good fitting accuracy Plug & play interchangeable no tapering for optimum air flow flow-optimised for better response behaviour Attention: Please check in advance whether your OEM Charge Pipe also has 2 screw connection points on the throttle valve.